Homepage | Add to Favorites | Chinese  |  English     
 
  Home | About Us | News Center | Product Center | Quality Assurance | Service Commitment | Download | Contact Us  
  Products  
Railway products
 Insulators
 GRP products
Power Line Products
 Insulators
 Fuse cut out
 Arresters
 Bushings
 Insulator manufacture equipment
 Insulator cores and fittings
Live Line Tools
 FRP hot Sticks
 Insulation Ladders
 HUBBELL Distribution Connectors
Fiberglass Insulation parts
Service Online
Tel:00869132128099
Fax:00869132128099
Mob:008618191816622
Email:sale@tidpower.com
Website:http://www.tidpower.com
Whatapp:+8618191816622
+8618392311600
Insulator manufacture equipment
TID3000KN Crimping machine for polymer insulator
Posted:2018-05-21 | Browse: 362 【Close this page


TID3000KN Crimping machine for polymer insulator


Technical parameters:

Item

Value

Max. force of crimp connection kN

3000

Working range

Up to 210KN

Max. working pressure of main die block, MPa

25

Max. operating opening of the machine ( including die set )

Max. Mould Crimping Diameter

Φ38

Max.Mould Openging Diameter

Φ81

Max. die length, mm

60

Main machine

L×B×H, mm

1180×820×1600

Weight, kg

1200

Hydraulic system

L×B×H, mm

910×790×1070

Weight ,kg

350 with out oil

Operation mode of crimp connection machine

Manual, Automatic

Control mode

PC control

Electrical Power KW

2.2

Efficient Volume of oil Tank L

136

Total Weight

1565

I. The crimp connection machine and its other functions

1. The single cylinder, which is key part, is adopted to perform the crimp connection for power fittings through cine bushing. In addition, high accurate, resistant to wear cylinder, piston rod and sealing elements are adopted to assure the excellent hermetization and durable working life of the machine;

2. The “flexible crimp connection” technique, that is, 6~12 minutes’ time crimp connection and 2 minutes’ time holding pressure is adopted;

3. Both amount of crimp connection and crimp connection pressure applied to controlling processing quality;

4. The machine possesses “pre-press”, “max. limited pressure”, “min. pressure, and “ amount of crimp connection” etc. functions and these parameters can be set and amended. After the parameters have been set the operation of the machine would be performed automatically;

5. There is a specific acoustic emission device for on-line detection and control during processing power fittings in the machine. The curves of “Acoustic emission energy-Time”, “Oil cylinder pressure-Time” can be displayed and the acoustic emission caused by material breakdown can be automatically determined (qualified or unqualified) as well;

6. The parameters and detected results of acoustic emission mentioned above can be stored, played back, and printed (a U-memory is offered to user’s computer for printing;

A cooling device is built-in the hydraulic system to assure continuous work of the machine during summer time (Cooling system should be prepared by user.).

pply for low pressure oil pump can be used as adjust travel of cylinder and the oil supply section for high pressure oil pump can be used as separate main system for tensile strength work test i.e. high pressure oil pump, proportional valve, energy accumulator etc. can be used to make sure that work is steady and hold pressure. The whole system is hydraulic stand for energy saving type.


Hot Line:0086-18191816622 Website:Http://www.tidpower.com
E-mail:sale@tidpower.com   CopyRight:TID Power